Static Control Products
ElectraSheen Sapphire II
Breathtaking Gloss / Diamond Hard!
The Hardest, Longest Lasting Floor Finish In the Industry. Anti Static - Reduces nuisance static discharge! Perfect for Hospitals and Health Care Facilities, Retail, Supermarkets and More!
The first thing your customers notice and a major component showing the value your Company places on cleanliness and aesthetics. But typical floor finishes get dull and dingy in no time and can cause irritating little static zaps (when walking and pushing carts) distracting customers and reducing value while becoming a cumbersome, time consuming floor maintenance nightmare.
Sapphire helps control static while providing THE highest luster, lowest maintenance and longest lasting shine in the Industry period.
Advances in the proprietary acrylic/urethane cross linking chemistry has made Sapphire possible. One try easily convinces the most discriminating floor care professional of Sapphire's unparalleled product superiority.
ElectraSheen Sapphire has a Diamond hard energy dissipating matrix that allows burnishing to levels 30 to 40% higher than conventional high gloss floor finishes while providing hardness levels 80 to 100% higher than THE most advanced finishes! In addition, Sapphire's unique ability to reduce tribocharging (user induced static discharge caused by contact and separation of a persons shoes or the wheels of carts against the flooring) has earned the Zap Stops Here award from United SCP. Sapphire provides superlative results on all types of standard resilient tile, vinyl composition, terrazzo, ceramic tile and sealed wood and may also be used to adjust the conductivity of ElectraGuard ESD Epoxy as well as other ESD static conductive flooring.
APPLICATION AND MAINTENANCE
Best results are obtained when the finish is applied to surfaces that are 60o F or warmer. Remove old finish or wax with a high quality finish stripper. Mop up or vacuum the stripping solution and rinse the floor thoroughly with clean water. Apply up to 2 thin coats on ESD Flooring, 5 thin even coats on standard flooring (see engineering note below)*, allowing the finish to dry for approximately 30-45 minutes between coats (depending on humidity, temperature and air movement). Recoating existing finish: Wash the floor with a neutral cleaner and allow it to dry. Apply thin even coats, allowing the finish to dry for approximately 30-45 minutes.
Routine maintenance program: Floor surfaces should be swept with a clean dry dust mop daily to remove abrasive loose dirt and sand. Damp mop floors with neutral cleaner often to remove soil, salt, and film deposits that can degrade the coating's gloss. Floors may be high speed burnished to restore the gloss and harden the finish. Spray Buff with ElectraShine for best results.
*Engineering Note:This product may be used to adjust the conductivity of ElectraGuard and other static conductive flooring. Its use will raise the floor's insulative properties and may be used to bring the flooring into the static dissipative (versus static conductive) range of electrical conductivity. Apply VERY THIN even coats. Test between coats (allowing 24 hours for the 1st coat to crosslink prior to testing). Do not over apply. 2 thin coats will raise the floors insulative properties substantially depending on the thickness of application.
SPECIFICATIONS PRICING AND SDS Sheet
*Note: Substantial Discount at 3+ Units!
This material is not a hazardous mixture as defined in 29 CFR 1919, 1200 and M.G.L. c. 111F. Safety glasses and gloves should be worn during application and handling. If ingested, drink milk, water, or fruit juice and induce vomiting with oil of ipecac. In the event of eye contact, flush area with water for 15 minutes. Consult with a physician. For detailed information consult MSDS sheet.
© 1996-2018 All rights
This page last Updated on
© 1996-2018 All rights Reserved
This page last Updated on