The ElectraGuard Tri-Layer System is often installed by the end user, painting contractors or the United SCP Installations Service Group. We feature a 24/7 installation hotline for this product should you require tech support on the weekends or after normal business hours. An overview of the installation instructions follows. NOTE: for full installation instructions CLICK HERE.

Step 1: ElectraGuard (general application instructions). Prepare substrate, install grounding foil, mask encumbrances and walls. Prepare the ElectraGuard carefully: Catalyzed ElectraGuard should be used within six hours of mixing, therefore prepare only the quantity necessary for immediate use.  Add the pre-measured catalyst to epoxy base.  Stir gently until the catalyst has been thoroughly mixed in (a low RPM drill may be used with a rotary mixing attachment but try to not beat air into the material).  Allow the catalyzed mixture to stand 5 minutes. Using a 3/8 nap high quality paint roller and extension handle roll a thin uniform coat on the prepared area. Work areas close to walls and doorways with smaller 4" wide roller as you progress. The initial coat will cover approximately 250 to 500 ft ² per gallon.  Allow the initial coat to dry for 5-7 hours or longer and  apply a second coat. Second coat coverage is approximately 500-600 ft2 per gallon.  Allow the second coat to dry for 8 to 12 hours and apply a third cost.  Third coat coverage is approximately 500-600 SF per gallon. Finished floors may be opened to light traffic, under normal curing conditions, after 12 hours. See full scale installation instructions for further details. Allow coats to cure for a minimum of 48 hours (good environmental airflow) or 72 hours (compromised environmental airflow) prior to proceeding to step 2 (topical coatings of ElectraThane Sealer).

Step 2: ElectraThane (general application instructions). Thoroughly remove loose dirt and dust from the cured ElectraGuard via sweeping (do not use sweeping compounds).  Remove imperfections if any (such as bubbles and splatters) from ElectraGuard via light scraping followed by vacuuming. Agitate ElectraThane sealant in container prior to use, pour into clean contaminant free bucket and mop on one thin even coat using non linting synthetic finish mops.  Allow coat to dry (depending on humidity and temperature) for 60 to 90 minutes before re-application of second thin coat. Two coats are or more are recommended. ElectraThane does not readily lend itself to high speed polishing but has a good as applied luster and excellent slip resistance.  Allow coats to cure for a minimum of 12 hours prior to proceeding to step 3 (topical coatings of ElectraGlaze Floor Finish). See ElectraThane page for full application instructions.

Step 3: ElectraGlaze (general application instructions). Using a clean Rayon finish mop or wax applicator, apply a minimum of one thin even coat of ElectraGlaze allowing finish to dry 2 to 4 hours prior to allowing traffic on floor.  Two coats are recommended for optimum performance. Buffing is not required unless high mirror like shine is desired. Note: Avoid application during high humidity conditions, use thin coats ONLY.  See ElectraGlaze page for full application instructions.